Stainless Steel Magnetic Pins
CMF Media
Stainless Steel Magnetic Pins
As low as
$21.16
- Steel Pins
- Heat treat scale removal
- High luster burnishing
- Edge smoothing/light radiusing
- Pins are available in .3 mm & .5 mm diameter
- Offered in 250g or 1 kilo buckets
- Use with Raytech Compound M Solution
In stock
SKU
SteelPins
For CMF machines only. Important! Under no circumstances should the pins be stored in the bowl on the machine. Doing so will cause the pins to magnetize, resulting in over-magnetizing of pins, thus lessening their effectiveness. Through use, discoloration (darkening) of the pins is normal. They can be cleaned using a tri-sodium phosphate solution. TSP is available at your hardware store.
Tech Tips
- Remove the bowl (1) from the machine and place it on the table.
- Place the separator (2) in the bowl to attract the pins. Because the parts are ferrous,only the pin swill be attracted to the magnetic separator.
- Once pins are attached to separator, remove separator from bowl. Place separator over cup (3) or container and pull trigger to release the pins.
- Repeat as needed until all pins are separated from parts.
Before
After

Unit Weight | varies |
---|---|
Speed | N/A |
Bowl / Chamber Diameter | N/A |
Rings Capacity | N/A |
Turbo Pins Capacity | N/A |
Motor HP | N/A |
Master Carton Box Measurements | N/A |
Master Carton / Box cu. ft. | N/A |